Description:
[JingMing] DK-J10 ABS Hop Up[For Jing Ming Gen.10 Gel Blaster]

• ABS Plastic Construction
• This product is adjustable friction HOP UP, dedicated to JM Gen.10 ACR.
• When installing, first unplug the original muzzle, then insert the top into the bottom so that the exhaust slot is facing down and the adjusting screw is facing up
• Rotate the upper screw with the included hex wrench to adjust the angle of the upper rotation to adapt to the water bomb of different sizes and hardness, when screwing the screw, please carefully screw it to prevent damage to the upper rotation.
• It is recommended that the size of the water bomb is 7.0-7.4mm, when using the digital caliper, measure the diameter of the water bomb, when it reaches 7.2mm, you can fish it out.
• Too much water will break the ball, friction plate adjustment position is too low will also break the ball.
• After the water bombs are good, be sure to drain the water and reuse, or dry the water on the towel again, otherwise the surface of the body will be too much moisture, which will weaken the effect of the upper friction and cause the urine bomb
• The upper inner tube interface is 9.2mm, only fits the original plastic inner tube.
• The principle of 3D printing is layer-by-layer manufacturing, which will inevitably produce lines and seams, this is a normal phenomenon, non-quality problems, and all the top-spin inspections are shipped after delivery to ensure that the inner wall is free of burrs
• The ABS plastic is a solid printed, the temperature resistance is far more than PLA, no need to worry about heat deformation in summer. .
• Adaptation: JM Gen.10 ACR Water Gel Beads Blaster

Specification:

• Part No.: DK-J10
• Colour: Black
• Weight: 80g
• Size: 65mm x 9.5mm x 19mm
• Compatibility: -14mm Screw Thread.

Package Contents:

1. Hop Up x 1pc